Re: Slow ADSL !

[Asa Liton <leyton@example.com>]

Tobias Diedrich wrote:

> Uva Coder wrote:
>
> > Using the '>' will overwrite (clobber, in unix speak) the contents
> > of the file. Use '>>' to append data to a file.

Thanks. I had another freez ( so another fresh INSTALLATION ).
It's a laptop
Sony VAIO PCG-Z505GR/K
Pentium III 650 MHz
Memory 128 MB
HDD 12 GB
CD-RW Drive PCGA-CDRW52 (external connected with a pc card)

Please see the attachment for the ifno you asked. Thank you.

Ahmed.
2.4.7-2
00:00.0 Host bridge: Intel Corporation 440BX/ZX - 82443BX/ZX Host bridge (rev 03)
00:01.0 PCI bridge: Intel Corporation 440BX/ZX - 82443BX/ZX AGP bridge (rev 03)
00:07.0 ISA bridge: Intel Corporation 82371AB PIIX4 ISA (rev 02)
00:07.1 IDE interface: Intel Corporation 82371AB PIIX4 IDE (rev 01)
00:07.2 USB Controller: Intel Corporation 82371AB PIIX4 USB (rev 01)
00:07.3 Bridge: Intel Corporation 82371AB PIIX4 ACPI (rev 03)
00:08.0 FireWire (IEEE 1394): Sony Corporation CXD3222 i.LINK Controller (rev 02)
00:09.0 Multimedia audio controller: Yamaha Corporation YMF-744B [DS-1S Audio Controller] (rev 02)
00:0a.0 Communication controller: CONEXANT SoftK56 Speakerphone Winmodem (rev 01)
00:0b.0 Ethernet controller: Intel Corporation 82557 [Ethernet Pro 100] (rev 08)
00:0c.0 CardBus bridge: Ricoh Co Ltd RL5c475 (rev 80)
01:00.0 VGA compatible controller: Neomagic Corporation NM2380 [MagicMedia 256XL+] (rev 10)

/dev/hda:
 multcount    = 16 (on)
 I/O support  =  0 (default 16-bit)
 unmaskirq    =  0 (off)
 using_dma    =  1 (on)
 keepsettings =  0 (off)
 nowerr       =  0 (off)
 readonly     =  0 (off)
 readahead    =  8 (on)
 geometry     = 1467/255/63, sectors = 23579136, start = 0
Linux version 2.4.7-2 (bhcompile@example.com) (gcc version 2.96 20000731 (Red Hat Linux 7.1 2.96-96)) #1 Tue Aug 14 05:16:54 EDT 2001
BIOS-provided physical RAM map:
 BIOS-e820: 0000000000000000 - 000000000009f800 (usable)
 BIOS-e820: 000000000009f800 - 00000000000a0000 (reserved)
 BIOS-e820: 00000000000e8400 - 0000000000100000 (reserved)
 BIOS-e820: 0000000000100000 - 0000000007ff0000 (usable)
 BIOS-e820: 0000000007ff0000 - 0000000007fff800 (ACPI data)
 BIOS-e820: 0000000007fff800 - 0000000008000000 (ACPI NVS)
 BIOS-e820: 00000000fff80000 - 0000000100000000 (reserved)
Scanning bios EBDA for MXT signature
On node 0 totalpages: 32752
zone(0): 4096 pages.
zone(1): 28656 pages.
zone(2): 0 pages.
Local APIC disabled by BIOS -- reenabling.
Could not enable APIC!
Kernel command line: ro root=/dev/hda3 hde=ide-scsi
ide_setup: hde=ide-scsi
Initializing CPU#0
Detected 645.217 MHz processor.
Console: colour VGA+ 80x25
Calibrating delay loop... 1287.78 BogoMIPS
Memory: 125048k/131008k available (1401k kernel code, 4676k reserved, 92k data, 232k init, 0k highmem)
Dentry-cache hash table entries: 16384 (order: 5, 131072 bytes)
Inode-cache hash table entries: 8192 (order: 4, 65536 bytes)
Mount-cache hash table entries: 2048 (order: 2, 16384 bytes)
Buffer-cache hash table entries: 4096 (order: 2, 16384 bytes)
Page-cache hash table entries: 32768 (order: 6, 262144 bytes)
CPU: Before vendor init, caps: 0383f9ff 00000000 00000000, vendor = 0
CPU: L1 I cache: 16K, L1 D cache: 16K
CPU: L2 cache: 256K
Intel machine check architecture supported.
Intel machine check reporting enabled on CPU#0.
CPU: After vendor init, caps: 0383f9ff 00000000 00000000 00000000
CPU:     After generic, caps: 0383f9ff 00000000 00000000 00000000
CPU:             Common caps: 0383f9ff 00000000 00000000 00000000
CPU: Intel Pentium III (Coppermine) stepping 03
Enabling fast FPU save and restore... done.
Enabling unmasked SIMD FPU exception support... done.
Checking 'hlt' instruction... OK.
POSIX conformance testing by UNIFIX
BIOS strings suggest APM reports battery life in minutes and wrong byte order.
mtrr: v1.40 (20010327) Richard Gooch (rgooch@example.com)
mtrr: detected mtrr type: Intel
PCI: PCI BIOS revision 2.10 entry at 0xfd9ae, last bus=1
PCI: Using configuration type 1
PCI: Probing PCI hardware
Unknown bridge resource 0: assuming transparent
PCI: Using IRQ router PIIX [8086/7110] at 00:07.0
Limiting direct PCI/PCI transfers.
isapnp: Scanning for PnP cards...
isapnp: No Plug & Play device found
Linux NET4.0 for Linux 2.4
Based upon Swansea University Computer Society NET3.039
Initializing RT netlink socket
ACPI BOOT descriptor is wrong length (39)
Simple Boot Flag extension found and enabled.
apm: BIOS version 1.2 Flags 0x03 (Driver version 1.14)
mxt_scan_bios: enter
Starting kswapd v1.8
VFS: Diskquotas version dquot_6.5.0 initialized
pty: 2048 Unix98 ptys configured
Serial driver version 5.05c (2001-07-08) with MANY_PORTS MULTIPORT SHARE_IRQ SERIAL_PCI ISAPNP enabled
ttyS00 at 0x03f8 (irq = 4) is a 16550A
ttyS02 at 0x03e8 (irq = 4) is a 8250
Real Time Clock Driver v1.10d
block: queued sectors max/low 82997kB/27665kB, 256 slots per queue
RAMDISK driver initialized: 16 RAM disks of 4096K size 1024 blocksize
Uniform Multi-Platform E-IDE driver Revision: 6.31
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
PIIX4: IDE controller on PCI bus 00 dev 39
PIIX4: chipset revision 1
PIIX4: not 100% native mode: will probe irqs later
    ide0: BM-DMA at 0xfcb0-0xfcb7, BIOS settings: hda:DMA, hdb:pio
    ide1: BM-DMA at 0xfcb8-0xfcbf, BIOS settings: hdc:DMA, hdd:pio
hda: TOSHIBA MK1214GAP, ATA DISK drive
ide2: ports already in use, skipping probe
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
hda: 23579136 sectors (12073 MB), CHS=1467/255/63, UDMA(33)
ide-floppy driver 0.97
Partition check:
 hda: hda1 hda2 hda3 hda4 < hda5 >
Floppy drive(s): fd0 is 1.44M
floppy0: no floppy controllers found
task queue still active
ide-floppy driver 0.97
Promise Fasttrak(tm) Softwareraid driver for linux version 0.02
No raid array found
Highpoint HPT370 Softwareraid driver for linux version 0.01
No raid array found
md: md driver 0.90.0 MAX_MD_DEVS=256, MD_SB_DISKS=27
md: Autodetecting RAID arrays.
md: autorun ...
md: ... autorun DONE.
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP, IGMP
IP: routing cache hash table of 512 buckets, 4Kbytes
TCP: Hash tables configured (established 8192 bind 8192)
Linux IP multicast router 0.06 plus PIM-SM
NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.
RAMDISK: Compressed image found at block 0
Freeing initrd memory: 307k freed
VFS: Mounted root (ext2 filesystem).
Journalled Block Device driver loaded
kjournald starting.  Commit interval 5 seconds
EXT3-fs: mounted filesystem with ordered data mode.
Freeing unused kernel memory: 232k freed
Adding Swap: 136512k swap-space (priority -1)
EXT3 FS 2.4-0.9.6, 11 Aug 2001 on ide0(3,3), internal journal
kjournald starting.  Commit interval 5 seconds
EXT3 FS 2.4-0.9.6, 11 Aug 2001 on ide0(3,2), internal journal
EXT3-fs: mounted filesystem with ordered data mode.
SCSI subsystem driver Revision: 1.00
scsi0 : SCSI host adapter emulation for IDE ATAPI devices
0x378: FIFO is 16 bytes
0x378: writeIntrThreshold is 8
0x378: readIntrThreshold is 8
0x378: PWord is 8 bits
0x378: Interrupts are ISA-Pulses
0x378: ECP port cfgA=0x14 cfgB=0x4b
0x378: ECP settings irq=7 dma=3
parport0: PC-style at 0x378 (0x778) [PCSPP,TRISTATE,COMPAT,ECP]
parport0: irq 7 detected
parport0: cpp_daisy: aa5500ff(28)
parport0: assign_addrs: aa5500ff(28)
parport0: cpp_daisy: aa5500ff(28)
parport0: assign_addrs: aa5500ff(28)
ip_conntrack (1023 buckets, 8184 max)
NET4: Linux IPX 0.47 for NET4.0
IPX Portions Copyright (c) 1995 Caldera, Inc.
IPX Portions Copyright (c) 2000, 2001 Conectiva, Inc.
NET4: AppleTalk 0.18a for Linux NET4.0
eepro100.c:v1.09j-t 9/29/99 Donald Becker http://cesdis.gsfc.nasa.gov/linux/drivers/eepro100.html
eepro100.c: $Revision: 1.36 $ 2000/11/17 Modified by Andrey V. Savochkin <saw@example.com> and others
PCI: Found IRQ 9 for device 00:0b.0
eth0: OEM i82557/i82558 10/100 Ethernet, 08:00:46:07:88:1E, IRQ 9.
  Receiver lock-up bug exists -- enabling work-around.
  Board assembly 100001-001, Physical connectors present: RJ45
  Primary interface chip i82555 PHY #1.
  General self-test: passed.
  Serial sub-system self-test: passed.
  Internal registers self-test: passed.
  ROM checksum self-test: passed (0x04f4518b).
  Receiver lock-up workaround activated.
Linux Kernel Card Services 3.1.22
  options:  [pci] [cardbus] [pm]
PCI: Assigned IRQ 9 for device 00:0c.0
PCI: Sharing IRQ 9 with 00:0a.0
Yenta IRQ list 0cb8, PCI irq9
Socket status: 30000419
cs: IO port probe 0x0c00-0x0cff: clean.
cs: IO port probe 0x0100-0x04ff: excluding 0x170-0x177 0x220-0x22f 0x330-0x337 0x370-0x37f 0x388-0x38f 0x398-0x39f 0x4d0-0x4d7
cs: IO port probe 0x0a00-0x0aff: clean.
cs: memory probe 0xa0000000-0xa0ffffff: clean.
hde: UJDA330, ATAPI CD/DVD-ROM drive
ide2 at 0x180-0x187,0x386 on irq 3
ide-floppy driver 0.97
ide_cs: hde: Vcc = 5.0, Vpp = 0.0
hde: bad special flag: 0x03
PCI: Enabling device 00:09.0 (0006 -> 0007)
PCI: Assigned IRQ 9 for device 00:09.0
ymfpci: YMF744 at 0xfecf0000 IRQ 9
ac97_codec: AC97 Audio codec, id: 0x414b:0x4d02 (Asahi Kasei AK4543)
ide-floppy driver 0.97
hde: driver not present
CSLIP: code copyright 1989 Regents of the University of California
PPP generic driver version 2.4.1
             total       used       free     shared    buffers     cached
Mem:        126484     121912       4572         56      13656      57084
-/+ buffers/cache:      51172      75312
Swap:       136512       5168     131344