Re: tlug: pine-jp compile problems

[Christopher Sekiya <wileyc@example.com>]

On Wed, 14 Jul 1999, Scott M. Stone wrote:

> Add '-lcrypt' to the end of the line beginning with LFLAGS= and then
> 'make clean' and 'make' again.

Come on, Scott, you can do better than that.  You must have been
building pine-j from someone else's RPM .spec, because those instructions
won't work.

Precisely where one adds the -lcrypt depends on which rev of linux you're
building for -- lnx (not recommended) or slx (better).

Add -lcrypt to the imap makefile (imap/c-client/osdep/Makefile, I think)
under the section that corresponds to the build -- either lnx or slx.

If you're building for slx, change all occurrences of pw_encrypt() to
crypt() in log_lnx.c, same directory.

Add -lcrypt to pine/makefile.lnx.  The same makefile is used for both lnx
and slx.

You do not need to do a 'make clean; make' -- in fact, you can't, because
pine builds are done via the build script.  Run './build lnx' or './build
slx' from the main source directory.

-- Chris (wileyc@example.com)

-------------------------------------------------------------------
Next Technical Meeting: August 14 (Sat), 13:00  place: Temple Univ.
*** Special guest: Marc Christensen (Salt Lake Linux Users Group)
Next Nomikai: September 20 (Fri), 19:30 Tengu TokyoEkiMae 03-3275-3691
-------------------------------------------------------------------
more info: http://www.tlug.gr.jp        Sponsor: Global Online Japan