tlug: here are my setup and relevant files

["Eric S. Standlee" <esstand@example.com>]

Obviously, if this got to the list, then I can send mail, although I have
a "deferred" email that is stuck in the mqueue dir in spool.

I am using sendmail and fetchmail still.  Rex, I wasn't able to find qmail
on my cdroms, and as I am a pinch I don't want to spend too much time ($)
on the internet...  I did get mutt up and running, but cannot figure out
how to get the POP part working.  The man and docs are vague on this and
when I hit "G" it says that key isn't binded...

My .fetchmailrc is just like my previous on (on debian load) and very
similar to the popclient one (neither of which worked but which I did put
out to the list before).

What do I do to get my mail off the pop servers I use???

Thanks again for tolerating this ISP dumb user...
Eric


lo        Link encap:Local Loopback  
          inet addr:127.0.0.1  Bcast:127.255.255.255  Mask:255.0.0.0
          UP BROADCAST LOOPBACK RUNNING  MTU:3584  Metric:1
          RX packets:168 errors:0 dropped:0 overruns:0
          TX packets:168 errors:0 dropped:0 overruns:0

ppp0      Link encap:Point-Point Protocol  
          inet addr:202.219.230.68  P-t-P:202.219.223.27  Mask:255.255.255.0
          UP POINTOPOINT RUNNING  MTU:1524  Metric:1
          RX packets:8 errors:0 dropped:0 overruns:0
          TX packets:9 errors:0 dropped:0 overruns:0

lo        Link encap:Local Loopback  
          inet addr:127.0.0.1  Bcast:127.255.255.255  Mask:255.0.0.0
          UP BROADCAST LOOPBACK RUNNING  MTU:3584  Metric:1
          RX packets:234 errors:0 dropped:0 overruns:0
          TX packets:234 errors:0 dropped:0 overruns:0

ppp0      Link encap:Point-Point Protocol  
          inet addr:202.219.230.68  P-t-P:202.219.223.27  Mask:255.255.255.0
          UP POINTOPOINT RUNNING  MTU:1524  Metric:1
          RX packets:8 errors:0 dropped:0 overruns:0
          TX packets:9 errors:0 dropped:0 overruns:0

Kernel IP routing table
Destination     Gateway         Genmask         Flags Metric Ref    Use Iface
202.219.223.27  *               255.255.255.255 UH    0      0        0 ppp0
127.0.0.0       *               255.0.0.0       U     0      0        2 lo
default         202.219.223.27  0.0.0.0         UG    0      0        0 ppp0