Re: [tlug] Printer Not Responding

[Scott VanDusen <Scott_VanDusen@example.com>]

Hi Dave,

Not sure if this will help or not, but I was getting a similar error as yours when running evolution:

> dave@example.com:~$ sudo printconf
> *** glibc detected *** double free or corruption (!prev): 0x08179528 ***

to fix it I ran evolution with this as prefix:

G_SLICE=always-malloc 

and the double free corruption error went away- so maybe if you do 

dave@example.com:~$ G_SLICE=always-malloc /usr/bin/printconf 

it will work. Of course you might have to change the directory for printconf, it might not be in /usr/bin

HTH

Scott VanDusen

**************** CAUTION - Disclaimer *****************
This e-mail contains PRIVILEGED AND CONFIDENTIAL INFORMATION intended solely for the use of the addressee(s). If you are not the intended recipient, please notify the sender by e-mail and delete the original message. Further, you are not to copy, disclose, or distribute this e-mail or its contents to any other person and any such actions are unlawful. This e-mail may contain viruses. Infosys has taken every reasonable precaution to minimize this risk, but is not liable for any damage you may sustain as a result of any virus in this e-mail. You should carry out your own virus checks before opening the e-mail or attachment. Infosys reserves the right to monitor and review the content of all messages sent to or from this e-mail address. Messages sent to or from this e-mail address may be stored on the Infosys e-mail system.
***INFOSYS******** End of Disclaimer ********INFOSYS***